Agromehanika AGT 850, Инструкция по эксплуатации

Страница: 71 / 90

INSTRUCTIONS FOR USE
AGT 850 / 860
64
ADJUSTMENT OF WIRE ROPE
Before connection, you must check tension of wire rope. If it is overstrained, it must be set again.
Wire rope can be adjusted in two positions – on the top part (fine adjustment) or on the bottom part
(rough adjustment).
Fine adjustment
Follow the procedure below to perform the adjustment:

Unscrew nuts (1 and 2);

Adjust tension of wire rope. Turn bolt (3) to the right
(clockwise) to loosen wire rope, and turn it to the left
(counter clockwise) to tension it; hold the nut (1) during
this procedure;

Tighten nuts (1 and 2).
Rough adjustment
Follow the procedure below to perform the adjustment:

Unscrew bolt (4 and 5);

Move safety guide (6) to desired length;

Tighten bolt (4 and 5).
Correct tension of wire rope:

When the spring (7) on the wire rope is not fully compressed, when the brake pedal is completely
depressed;

When there is certain minimal gap between spring (7) and lever (8), when the brake pedal is
released.
WARNING: Brake system of the tractor does not allow separate operation of
foot and hand brake. Due to pressure in the pressure circuit of the tractor
with activated brakes, connecting or disconnecting can be performed only
when the brake is not engaged!
WARNING: Because the wire rope is connected only with one pedal, both
brake pedals must be mechanically connected with a pin during driving!
WARNING: When the pedal is fully depressed, the spring must never be
completely compressed!