Agromehanika AGT 850, Инструкция по эксплуатации

Страница: 51 / 90

INSTRUCTIONS FOR USE
AGT 850 / 860
44
2. Rear connection shaft (PTO) switch
If you press the switch, you engage rear connection shaft (PTO). Control
light on the switch is on. Press the switch again to disengage rear connection
shaft.
Engaging rear connection shaft:

In position 1, rear connection shaft (PTO) is disengaged (control light on the
switch is off).

In position 2, rear connection shaft (PTO) is engaged (control light on the
switch is on).
3. Differential lock switch
Press the switch to activate differential lock. Control light on the switch
turns on. Press the switch again to deactivate differential lock.
Activating differential lock
In position 1, differential lock of front and rear axle is deactivated (control
light on the switch is off).
In position 2, differential lock of front and rear axle is activated (control light on the
switch is on).
4. Main ignition switch
Activates electrical system and starts the tractor engine. Key can be turned to following positions:
0 – Deactivation of electrical system, you can remove the key
1 – Activation of electrical system. Warning lights for oil pressure in engine and
electrical voltage turn on on the dashboard, as well as control light of glow
plugs, which means that, in this position, also glow plugs in the engine begin
to heat.
2 – Engine start, hold key in position 2 until it starts. When you release the key, it
automatically returns to position 1.
5. Switch for lights and sound signal (horn)
Rotate the switch to left and right to activate certain levels of light:

In position 0, deactivated, lights are off.

In position 1, position lights turn on and remain on even if the
main ignition switch is turned off.

In position 2, position lights turn on, but stay on only if the main
ignition switch is turned on (key must be in position 1).

In position 3, low beam lights turn on, but stay on only if the
main ignition switch is turned on (key must be in position 1).

In position 4, high beam lights turn on, but stay on only if the
main ignition switch is turned on (key must be in position 1).
If you press switch (5), you activate sound signal (horn).
0
1
2
0
1
2
3
4
5