
Operation
4-13
Pressure Sensitive Process (Reverse)
1. Load film on the rear upper unwind station. Turn the brake to zero.
2. Set the shim wheels to “0” on the pull rolls and 1" on the nip rolls, place a piece of feeder stock
into the pull rolls with plenty of stock hanging out the front. Close the pull rolls onto the piece of
feeder stock.
The nip section can pull you into laminator! Do not place fingers
into the nip section when the rolls are rotating. It is
recommended that operators tie long hair back and not wear
neckties, loose clothing and jewelry since they can be caught in the nip section and pull the
operator into the machine
3. Pull the film from the upper rear station down to the top of the upper pull roller, separate the
release liner from the film and stick the film to the feeder stock.
4. Route the release liner up and over the film roll to the front upper windup station. Tape the
release liner to the wind up core.
5. Select the reverse direction, set the speed adjust wheel to a low setting.
6. Set shim wheel on pull rolls based your substrate you are using.
7. Place substrate into pull rolls and close pull rolls.
8. Using your process sheets, make all the initial settings for your process. Machine is now ready to
laminate. Follow the procedures in operation to start your prints and set machine in run mode.
9. Place graphic onto board and run through laminator in reverse. (see operation section for mode
sequences)
Содержание Encore Maxim
