AGL Encore Maxim, Руководство оператора, Страница: 15 / 73

Operation
4-9
Encapsulation Process
1. Load thermal film on the rear upper and lower unwind stations. Turn the brake to zero.
2. Set temperature on upper and lower nip rolls and allow rolls to balance at temperature.
3. Set the shim wheels to “0” on both the nip rolls and pull rolls.
The nip section can pull you into laminator! Do not place fingers
into the nip section when the rolls are rotating. It is recommended
that operators tie long hair back and not wear neckties, loose clothing and jewelry since they
can be caught in the nip section and pull the operator into the machine
4. Pull the film from the upper rear station down under the idler roller directly behind the nip roll and
over the top of the top nip roll. Be sure film is wetting out on the upper roll.
5. Lower infeed table and pull film between the lower nip roll and idler roll up over table. Hold film
with one hand and close infeed table with other hand.
6. Pulling film taut, place lower film against the wet out adhesive on the upper roll. With nip rolls
open, push film into the nip opening.
7. Select the forward direction, select a low speed setting with the speed adjust wheel, step on foot
switch as the nip rolls are closed. The rolls should pull the film into the nip.
8. Route the film through the chiller rolls (see chiller roll paths) then through the pull rolls.
9. Pull the web tight and close the pull rolls.
10. If your machine is equipped with optional product windup, route the web down to windup core and
tape to core.
11. Using your process sheets, make all the initial settings for your process. Machine is now ready to
laminate. Follow the procedures in operation to start your prints and set machine in run mode.