AGL Encore Maxim, Руководство оператора

Страница: 7 / 73

Operation
4-1
General
1. Power: A switch in the lower right rear switches the main power on and off. The switch is labeled
clearly so the operator can tell if the power is on or off.
2. Reset: A reset button is used to start the machine initially and restart the machine after an E-stop
condition has occurred. After the power is turned on, the reset button is held for 15 seconds to allow
the machines electrical controls to reset to initial settings.
3. Speed: A potentiometer thumb wheel located on the top of the RH enclosure is used to control the
speed that the laminator will run product through. Your laminator has the electrical and mechanical
capability to run up to 15 feet per minute, but the quality of the product output is the governing factor
in maximum process speed.
4. E-stops: E-stop switches are located at all four corners to allow the operator to stop the machine and
open the nip rolls and pull rolls in case of emergency. The button must be pulled back out before
pressing the reset button to restart the machine.
5. Nip Rolls: The nip rolls are the heart and soul of the laminator and must be cared for properly in
order to give years of quality product output. Always dial the shim wheel to a shim setting greater
than “0” when the machine is not in use. This will prevent the rolls from forming a flat spot from
resting against each other. This also applies to the pull rolls.
Always set the shim wheel to a setting greater than “0” when the
machine is not in use. This will prevent the roll from coming together
and forming a flat spot. Permanent damage can be caused to the rolls
if this warning is not heeded.
6. Fwd-Stop-Rev: There are a set of 3 buttons located on the top of the RH enclosure used to select the
direction of the machine and to stop the machine. When standing in front of the machine, the green
lit button that is farthest away from you is the reverse button, the red lit button is the stop button and
the green lit button closest to you is the forward button.
7. Foot Switch: The foot switch will run the laminator in the direction depicted by the Fwd/Rev button
and at the speed set by the potentiometer. The foot switch is always active, this allows an operator to
press the foot switch to get a print started and then press the direction button to transfer to the
continuous run mode without stopping.
8. Temperature Control with switch: The two position switch allows the operator to turn the heater in the
roll on or off. The temperature controller allows the operator to set a desired temperature for a
process.
9. Fan On/Off- This switch will turn on and off the web cooling fans if equipped. The button will
illuminate when the fans are on.
10. Nip Roll open/close- This switch will open and close the nip rolls. When the switch selects the roll to
close the switch will illuminate.
11. Pull Roll open/close- This switch will open and close the pull rolls. When the switch selects the roll to
close the switch will illuminate.
12. Regulators- The regulators are used to control the air pressure to the cylinders for the nip and pull
rolls. The regulator knob is turned clockwise to increase pressure and counter clockwise to decrease
pressure.
13. Guages- The guages on the front and rear panels show the air pressure supplied to the nip and pull
rolls. This will be a very repeatable reading that can be documented for quicker setups on jobs.