AGL Encore Maxim, Руководство оператора

Страница: 17 / 73

Operation
4-11
Pressure Sensitive Top and Bottom Process
1. Load film on the rear upper and lower front unwind station. Note that the lower front station
cannot be used for a pressure sensitive film with a release liner. Turn the brake to zero.
2. Set temperatures on upper and lower rolls if required by film and allow to balance at temperature.
3. Set the shim wheels to “0” on both the nip rolls and pull rolls, place a piece of feeder stock into
the nip rolls with plenty of stock hanging out the front. Close the nip rolls onto the piece of feeder
stock.
The nip section can pull you into laminator! Do not place fingers
into the nip section when the rolls are rotating. It is
recommended that operators tie long hair back and not wear
neckties, loose clothing and jewelry since they can be caught in the nip section and pull the
operator into the machine
4. Pull the film from the upper rear station down under the idler roller directly behind the nip roll and
over the top of the top nip roll. Separate the release liner from the film and stick the film to the
feeder stock.
5. Route the release liner up to the front upper windup station. Tape the release liner to the wind up
core.
6. Lower infeed table and pull film up in front of the idler roll and stick to lower side of feeder stock.
7. Select the forward direction, set the speed adjust wheel to a low setting an move to the rear of the
machine.
8. Using the footswitch, run web to pull rolls and close the pull rolls.
9. With web pulled through laminator, you can now lift the infeed table into its locked position.
10. If your machine is equipped with optional product windup, route the web down to windup core and
tape to core.
11. Using your process sheets, make all the initial settings for your process. Machine is now ready to
laminate. Follow the procedures in operation to start your prints and set machine in run mode.