Agilent Technologies E3631-90002, Руководство пользователя, Страница: 122 / 166

Chapter 5 Error Messages
Calibration Errors
121
5
Calibration Errors
The following errors indicate failures that may occur during a calibration.
Refer to the
Service Guide
for more information.
701
Cal security disabled by jumper
The calibration security feature has been disabled with a jumper inside the
power supply. When applicable, this error will occur at power-on to warn
you that the power supply is unsecured.
702
Cal secured
The power supply is secured against calibration.
703
Invalid secure code
An invalid calibration security code was received when attempting to
unsecure or secure the power supply. You must use the same security code
to unsecure the power supply as was used to secure it, and vice versa. The
security code may contain up to 12 alphanumeric characters. The first
character must be a letter.
704
Secure code too long
A security code was received which contained more than 12 characters.
708
Cal output disabled
Calibration is aborted by sending
OUTP OFF
command during calibrating a
output.
711
Cal sequence interrupted
Calibration sequence is interrupted by changing the instrument selection
during calibrating an output.
712
Bad DAC cal data
The specified DAC calibration constants (
CAL:VOLT
or
CAL:CURR
) are out of
range. Note that the new calibration constants are not stored in the
non-volatile memory.
713
Bad readback cal data
The specified readback calibration constants (
CAL:VOLT
or
CAL:CURR
) are
out of range. Note that the new calibration constants are not stored in the
non-volatile memory.