Agilent Technologies E3631-90002, Руководство пользователя

Страница: 119 / 166

Chapter 5 Error Messages
Execution Errors
118
-222
Data out of range
A numeric parameter value is outside the valid range for the command.
Example:
TRIG:DEL -3
-223
Too much data
A character string was received but could not be executed because the
string length was more than 40 characters. This error can be generated by
the
CALibration:STRing
command.
-224
Illegal parameter value
A discrete parameter was received which was not a valid choice for the
command. You may have used an invalid parameter choice.
Example:
DISP:STAT XYZ
(
XYZ
is not a valid choice).
-330
Self-test failed
The power supply's complete self-test failed from the remote interface
(
*TST?
command). In addition to this error, more specific self-test errors
are also reported.
See also “Self-Test Errors”, starting on page 120
.
-350
Too many errors
The error queue is full because more than 20 errors have occurred. No
additional errors are stored until you remove errors from the queue. The
error queue is cleared when power has been off, or after a
*CLS
(clear
status) command has been executed.
-410
Query INTERRUPTED
A command was received which sends data to the output buffer, but the
output buffer contained data from a previous command (the previous data is
not overwritten). The output buffer is cleared when power has been off, or
after a
*RST
(reset) command has been executed.
-420
Query UNTERMINATED
The power supply was addressed to talk (i.e., to send data over the
interface) but a command has not been received which sends data to the
output buffer. For example, you may have executed an
APPLy
command
(which does not generate data) and then attempted an
ENTER
statement to
read data from the remote interface.