Agilent Technologies 33120A, Руководство пользователя

Страница: 240 / 312

Calibration Errors
The following errors indicate failures that may occur during a
calibration. Refer to the
Service Guide for more information.
701
Cal security disabled by jumper
The calibration security feature has been disabled with a jumper inside
the function generator. When applicable, this error will occur at
power-on to warn you that the function generator is unsecured.
702 Cal secured
The function generator is secured against calibration.
703 Invalid secure code
An invalid calibration security code was received when attempting to
unsecure or secure the function generator. You must use the same
security code to unsecure the function generator as was used to secure it,
and vice versa. The security code may contain up to 12 alphanumeric
characters. The first character
must be a letter.
704 Secure code too long
A security code was received which contained more than 12 characters.
705
Cal aborted
A calibration in progress is aborted when you press any front-panel key,
send a device clear, or change the local/remote state of the instrument.
706 Cal value out of range
The specified calibration value (
CAL:VALUE
) is invalid for the presently
selected function.
707 Cal signal measurement out of range
The specified calibration value (
CAL:VALUE
) does not match the signal
applied to the function generator.
708 Flatness cal failed
709 Cannot calibrate frequency while externally locked
You cannot perform
CAL:SETUP 0
or
CAL:SETUP 86
while the function
generator is externally phase locked ( Option 001 ).
760 RAM checksum failure
Chapter 5 Error Messages
Calibration Errors
238