AEP Networks ATAG VA4511AT, Руководство пользователя

Страница: 27 / 67

- 27 -
10.2001 A. B. 599 51 21 26 EN
- Change cycle (after a successful cycle start)
o
The cycle can be changed after the cycle start at any time.
+
The new set cycle is executed from the very beginning!
o Actuate the key of the desired new cycle for approx. 3 seconds.
+
During the time is changed, the LEDs of the previous and of the new cycle will
flash. If the cycle option key was set in addition to the previous washing cycle,
then this key does not flash.
+ After the change has been finished, only the LED of the new set cycle will light.
o The cycle starts automatically and immediately.
o Here it is not possible to enter a start-time or to set the cycle option key. This can only
be set after a completely new start, i.e. after the washing cycle has been cancelled.
- Interrupt the cycle / pause mode
o
General information:
o With the ON/OFF key T1 or by opening the door, you can interrupt the cycle without any
losses as long as one wants. This corresponds to a “pause” function.
o During the pause time, no rinse-relevant data will go lost. The cycle will be continued
exactly at that point where it was stopped.
Attention: However, such a pause may have a negative effect on the automatic load
detection.
o When the running cycle is interrupted in certain washing cycles after regenerating, i.e.
by means of the cycle part “drying” (please conclude details from the cycle run), the
cycle will be stopped and the a
o Another proceeding is required to cancel an already set and started cycle.
(see chapter “Cancel a Cycle”).
o Switch off the appliance during the washing process.
+
The ON/OFF key T1 can thus be regarded as “pause” key.
+ The cycle run is continued after re-putting into service by the ON/OFF key T1 after
approx. 3 seconds, without that another key actuation becomes necessary.
+ All displays and conf
o The door is opened during the running cycle.
+
The opening of the door can thus be regarded as a “pause” key.
+ After the opening, all displays keep to be on the panel, as long as the appliance
keeps to be switched on.
+ When the door is closed, the appliance starts automatically and the cycle run is
continued after approx. 3 seconds, without that another key actuation becomes
necessary.
o The cycle is stopped due to a power failure.
+
When the mains have returned, the appliance is again in the same state as before
the power failure.
+ No rinse-relevant data will go lost.
+ All displays and confirmations appear in the same condition as before the
interruption. When the remaining time is indicated, there may be differences in the
still remaining time before and after.
+ When the mains have returned, the cycle starts automatically and without any
further key actuation.