AEMC OX7102-CII, Руководство пользователя

Страница: 75 / 208

Oscilloscope Mode - The "Display" Menu
IV - 76 SCOPIX Oscilloscopes
Oscilloscope Mode (cont'd)
Full screen Switches from the normal display mode to the “full screen” display mode
and vice versa.
The display is organized so as to leave the biggest surface area possible
for trace plotting: only the permanent settings and the automatic or
manual measurements remain
•
This function has the same effect as the key.
•
The “ ” symbol indicates that the full screen mode is active.
This function can also be called up by double-pointing with the stylus on
the trace display area.
The settings defined on the front panel remain active.
The following sub-menus can be used to switch from oscilloscope mode
to XY mode.
The “ ” symbol indicates the active mode.
Oscilloscope This is the basic operating mode.
XY
Example
The “XY source” menu is used for assigning the desired traces to the
X axis (horizontal) and Y axis (vertical).
Validation of the selections by " OK ". Exit from the menu without modification
by " Cancel ".
•
Each axis is graduated into 8 divisions .
•
The selected traces are identified by a figure corresponding to their
axis .
•
The “ ” symbol indicates the trace selected for each axis.
Two sinusoidal signals assigned to the X and Y axis with an offset of
π
/2
are then represented by a circle.