Aeca Tarom MPPT 6000, Инструкция по установке и эксплуатации

Страница: 58 / 92

4.2 Installing the device
ATTENTION!
Danger of damage to the inverter and reduction of power. Observe the following safety require-
ments during installation:
– The mounting location and immediate environment are permanently fixed, vertical, flat, non-
inflammable and not subject to constant vibration.
– A free space of at least 60 mm must be present on all sides of the controller (
③
in Fig. 2,
p. 15).
– The controller must be easily accessible and the display easily readable.
– The controller is mounted as close as possible to the battery; the prescribed minimum safety
clearance of 0.5 m between the controller and battery is adhered to.
– The controller must not be located
–
outdoors or in a location subject to rain or splashing water,
– in dusty environments,
– in stalls with active animal husbandry,
– in direct sunlight.
– The battery cable is no longer than 2 m (recommended), to keep cable losses and the com-
pensation voltage as low as possible.
– Do not drill through the fastening openings
①
/
②
(Fig. 2).
1. Select the mounting location under consideration of the previously mentioned safety require-
ments.
2. Position the controller level on the mounting surface and mark the mounting holes through
the fastening openings
①
/
②
.
Note
The keyhole form of the two upper fastening holes makes it possible to first install the
screws for
①
and then mark the holes to be drilled for
②
with the device hung in place
(lower risk of incorrectly positioned drilled holes).
3. Remove the controller and drill the mounting holes.
GB
749.126 | M02 | 2013-11-13 14