Aeca Tarom MPPT 6000, Инструкция по установке и эксплуатации

Страница: 81 / 92

11.3 Dismounting the controller
DANGER!
Risk of death by electrocution.. Only technical professionals may perform the work described in
this section. Observe the safety instructions in Ä 4.1, p. 12.
WARNING!
Danger from hot surfaces. Allow the heatsink on the rear of the device to cool down before
touching.
Switch all cables free of voltage and remove the terminal cover
1. Switch off the DC load circuit breaker (solar module) and secure it against being switched on
again. With 2 solar modules, switch off
both DC load circuit breakers.
2. Switch off the external battery fuse: Remove the fuse insert from the fuse holder (safety fuse)
or switch off the DC line circuit breaker and secure it against being switched on again.
3. Remove the terminal cover.
Disconnect the solar module
u Disconnect module cables M1−/M1+ and – if present – M2−/M2+ from the controller and
insulate the cable ends.
Disconnect the battery from the controller
u Disconnect the battery cables B− and B+ from the controller and insulate the cable ends.
Disconnect PE from the controller
u Disconnect the PE cable from the controller.
Finish dismounting
1. If present, disconnect any remaining components from the controller.
n
Battery voltage sensor cable: First disconnect the cable from the battery and then from
the controller.
n
External battery temperature sensor: Disconnecting this from the controller only is suffi-
cient.
2. Remove the controller from the mounting surface.
11.4 Disposal of the controller
Do not dispose of the device in the normal household waste. Dispose of the device at the collection
point provided for this in your country or send the device at the end of its service life to Steca cus-
tomer service with a note stating
Zur Entsorgung (For disposal).
The device packaging consists of recyclable materials.
GB
749.126 | M02 | 2013-11-13 37