Aeca Tarom MPPT 6000, Инструкция по установке и эксплуатации

Страница: 57 / 92

– Mount the external battery fuse directly next to the battery.
– The external battery fuse must conform to the specifications in the technical data section.
– The external battery fuse is not included in the scope of delivery.
WARNING!
Danger of acid injuries.
– Do not subject the battery to open flames or sparks.
– Provide adequate ventilation in the installation location of the battery. Inflammable gases can
escape from the battery.
– Follow the charging instructions of the battery manufacturer.
CAUTION!
Danger of bodily injury. The device weighs over 6 kg. If in doubt, install the device with two per-
sons.
ATTENTION!
Danger of destroying the device through overloading
– Conform to the technical specifications, especially the connection values. See type plate and
Technical data section.
– When selecting the solar module, note that the open-circuit module voltage is higher than the
value specified on the type plate at temperatures below 25 °C.
– Do not connect the solar module to 2 controllers in parallel. The solar module can however be
connected in parallel to both solar module inputs of one controller. Make the appropriate set-
tings under Battery settings
▶
String connection !
– We recommend installing a fuse in the battery voltage sensor cable.
GB
749.126 | M02 | 2013-11-13 13