Additel 761A, Руководство пользователя

Страница: 140 / 151

120
6. Application
6.1 Unit conversion
 Click the menu in the upper right corner on the main interface to select the application, and then enter the
pressure unit converter.
 Supports conversion between multiple pressure units.
6.2 Pressure leak test
There are two pressurization ways of pressure leak detection:
a) Calibrator pressurization: Select the internal high or low pressure range, and the calibrator will automatically run
the test.
b) External pressurization: Select an external pressure module and use external pressure generation to run the
leak test.
1. Setup
 Select the application in the function menu to enter the pressure leak test.
 Click the upper area on the interface to select the range: Select the internal module range or the external pressure
module.
1) If the external pressure module is selected, there is no need to set the pressure target value;.

Select the pressure unit: If the selected unit is not supported by the selected module, it will automatically revert
to the last setting.

Set point
1) There is no need to set this parameter when selecting the external pressure module.