ABB REL650 series, Руководство по вводу в эксплуатацию

Страница: 48 / 208

If the CT secondary circuit earth connection is removed without the
current transformer primary being de-energized, dangerous voltages
may result in the secondary CT circuits.
4.8 Checking VT circuits
M11724-2 v10
Check that the wiring is in strict accordance with the supplied connection diagram.
Correct possible errors before continuing to test the circuitry.
Test the circuitry.
• Polarity check when applicable; this test is often omitted for CVTs
• VT circuit voltage measurement (primary injection test)
• Earthing check
• Phase relationship
• Insulation resistance check
The primary injection test verifies the VT ratio and the wiring all the way from the
primary system to the IED. Injection must be performed for each phase-to-neutral
circuit.
While testing VT secondary circuit and associated secondary
equipment, care shall be exercised to isolate the VT from the circuit
being tested to avoid backcharging the VT from the secondary side.
4.9 Using the RTXP test switch
GUID-F1E29C06-7FE8-44D8-AD5A-EE8990A2AA41 v5
The RTXP test switch is designed to provide the means of safe testing of the IED.
This is achieved by the electromechanical design of the test switch and test plug
handle. When the test plug handle is inserted, it first blocks the trip and alarm
circuits then it short circuits the CT secondary circuit and opens the VT secondary
circuits making the IED available for secondary injection.
When pulled out, the test handle is mechanically stopped in half withdrawn
position. In this position, the current and voltage enter the protection, but the alarm
and trip circuits are still isolated and the IED is in test mode. Before removing the
test handle, check the measured values in the IED.
Section 4
1MRK 506 383-UEN A
Starting up
42 Line distance protection REL650 2.2 IEC
Commissioning manual