ABB i-bus KNX, Руководство по эксплуатации продукта, Страница: 177 / 264

ABB i-bus
®
KNX
Commissioning
FCA/S 1.x.x.1 | 2CDC508134D0202 175
Scan input after download,
ETS reset and bus voltage recovery
Options: No
Yes

No: The object value is not scanned after a download, ETS reset and bus voltage recovery.

Yes: The object value is scanned after a download, ETS reset and bus voltage recovery.
Dependent parameter:
Inactive wait state after bus voltage
recovery in s [0…65,535]
Options: 0
…65,535
Here the waiting time after a bus voltage recovery is set. After the waiting time has elapsed the
state on the input terminals is scanned. The input reacts as if the state on the input terminals has
just changed.
Note
The inactive waiting time does not add to the actual, adjustable sending delay time. This can be
set separately.
Enable communication object
"Start event 0/1" 1-bit
Options: Yes
No

Yes: The 1-bit communication object Start event 0/1 is enabled. As a result, the same events, such as
those of the push button/switch connected to the binary input, can also be triggered by the receipt of a
telegram on the communication object
Start event 0/1 .
Enable communication object
"Block" 1-bit
Options: No
Yes

Yes: The 1-bit block communication object Block is enabled. This can be used to disable the input.
Notes
If the input is disabled and the option Send cyclically is set, the last state is still sent regardless of the
block. The option Block still blocks the physical input, sending continues internally.
Should the internal block with this input not be permitted, this communication object has no effect on the
respective input.