A&D GF-10202M, Инструкция по эксплуатации

Страница: 80 / 148

80
Setting the function table
Parameter settings for each output mode are as follows:
Item
Mode
Data output
mode
Auto print
polarity,
difference
Data
memory
function
Interval time
Key mode prt 0 Not used data 2
Not used
Auto print mode A prt 1 ap-a 0
～
2
ap-b 0
～
2
data 2
Auto print mode B prt 2
data 2
Key mode B
（
immediate
）
prt 4
Not used
data 2
Key mode C
（
stable
）
prt 5 data 2
Interval output mode
prt 6 data 2 int 0
～
8
Parameter settings for Data number, ID number, Time and Date
Data number
No d-no " 0 "
T
Time
and date
No 5-td 0
－
Yes
d-no
"
1
" Time only
5-td 1
Up to 200
pieces
ID number
No 5-id " 0 " Date only 5-td 2
Yes 5-id " 1 " Both 5-td 3
Recalling the memory data
Confirm that the "Data memory ( data )" parameter is set to " data 2 ".
1. Press and hold the PRINT key (for 2 seconds) until
is displayed, then release the key.
The type of data appears in the upper left of the display as shown to
the right "
-d- or d-t " .
2. Press the PRINT key to enter the memory recall mode.
Recall the data in memory using the following keys.
RE-ZERO key ..... To proceed to the next data set.
MODE key .......... To go back to the previous data set.
PRINT key .......... To transmit the current data using the RS-232C or USB.
CAL key .............. To exit the memory recall mode.
3. Press the CAL key to return to the weighing mode.
* It is also possible to change the time / date output setting after storing the weighing value.
When setting without clock / date
or
When setting with clock / date
Left of the display