3M Tape Application Monitor, Инструкция и перечень запасных частей

Страница: 17 / 62

North American - ENG
Date Released:
05-22-18
TAM Application Monitor - Yype 21800
Page 11
44-0009-2048-6 / ECO# 0078483
6) Place the edge of the template on the mark made
in step 5 also fl ush to the outer edge of the
case sealer frame.
7) Mark the hole locations as shown in (Figure 2-10).
Figure 2-10
Template
Previous
Mark
Drill Holes
Figure 2-11
8) Remove the lower taping head from the case
sealer and drill a 0.25 inch (6.5mm) hole at the
marks made in step 7.
Note: Carefully remove any burrs on the case
sealer frame before fastening the dancer
arm assembly.
9) Fasten the dancer arm assembly to the case
sealer frame using (2) M6 screws, washers and
the nut plate as illustrated in Figure 2-11.
10) Reinstall taping head without the tape
supply roll.
11) Verify that the dancer arm roller is in contact with
the empty tape drum.
• To reduce the risk associated with metal
fl yings or hot surface hazards:
− Use proper personal protective equipment
when drilling mounting holes
Caution
Installation and Set-Up
(continued)