3M Tape Application Monitor, Инструкция и перечень запасных частей

Страница: 25 / 62

North American - ENG
Date Released:
05-22-18
TAM Application Monitor - Yype 21800
Page 19
44-0009-2048-6 / ECO# 0078483
Installation and Set-Up
(continued)
Press the “PARAMETERS OTHER” Page
to display the HMI display shown (Figure 2-21)
Starting with the BELT SPEED press the
button to set the following:
0: 78 FPM Belt Speed
1: 102 FPM Belt Speed (FACTORY SETTING)
2: 150 FPM Belt Speed
Set the TAPING HEAD OFFSET:
0: STANDARD (FACTORY SETTING)
1: EXTENDED
When completed, press the “PAGE EXIT” to
return to the main menu.
Press the “MONITOR VELOCITIES” Page to
display the HMI display shown in Figure 2-22.
This screen is used to check the tape velocities
to ensure that both the tape apply and cut
velocities are in acceptable ranges after setup.
When completed, press the “PAGE EXIT” to return to the main menu.
• To reduce the risk associated with
mechanical and electrical hazards:
− Read, understand, and follow all safety
and operating instructions before
operating or servicing the case sealer.
− Allow only properly trained and quali fi ed
personnel to operate and service this
equipment.
Warning
Warning
• To reduce the risk associated with
pinches, entanglement and
hazardous voltage:
− Turn electrical supply o ff and
disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
BELT SPEED
78 [FPM] (0)
102 [FPM] (1)
150 [FPM] (2)
TAPING HEAD
OFFSET
STD (0)
EXTENDED (1)
PAGE
EXIT
Figure 2-21
1 0
UPPER
LOWER
PAGE
EXIT
APPLY CUT
18
20
4
6
Figure 2-22