3M Tape Application Monitor, Инструкция и перечень запасных частей

Страница: 21 / 62

North American - ENG
Date Released:
05-22-18
TAM Application Monitor - Yype 21800
Page 15
44-0009-2048-6 / ECO# 0078483
To Attach the Brackets:
1) Clean the general area where the brackets are to
be mounted. Do not remove the fi nal
position mark.
Note: It is very important that this area is clean and
dry to insure proper adhesion to surface.
Use a water/alcohol solution mixture or
equivalent cleaner approved for use on
powder coat paint.
2) Remove the VHB tape liner(s) and “lightly” press
the brackets into position.
3) Recheck sensor/re
fl ector alignment before
“ fi rmly”pressing on each bracket to permanently
mount the sensor and re fl ector assemblies.
4) Attach the sensor guard (See Figure 2-16).
Completing the Electrical Systems Connections
The remaining sensors must be connected. Each
dancer arm assembly has (2) proximity sensors, a tape
dispense and a low tape supply sensor.
1) Turn o ff and disconnect the power to the
control box.
2) Identify and route the control cables to the
appropriate locations de fi ned by bracket mounting.
The cables are marked to indicate the appropriate
sensor connection (i.e. UD - Upper Dispensing
sensor, US - Upper low tape Supply sensor,
LD - Lower Dispensing sensor, LS - Lower low
tape Supply sensor).
Important: Cables must remain clear of moving
parts and free to move if a ff ected by
machine adjustment.
3) Use the cable ties and cable mounts contained in
this kit to secure the control cables to the case
sealer.
Note: It is very important that this area is clean and
dry to insure proper adhesion to surface.
Use a water/alcohol solution mixture or
equivalent cleaner approved for use on
powder coat paint.
4) Connect the appropriate control cable connectors
to each proximity sensor.
5) Connect the case sealer power cord to control box
assembly and restore power (See Figure 2-16) .
Important: The 800rks and 800rf case sealers
require 3 phase electrical power.
The standard con fi guration will not
connect directly to these machines.
Contact a 3M sales representative for
additional information.
Figure 2-16
Warning
• To reduce the risk associated with
pinches, entanglement and
hazardous voltage:
− Turn electrical supply o ff and
disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
Installation and Set-Up
(continued)