3M Tape Application Monitor, Инструкция и перечень запасных частей

Страница: 33 / 62

North American - ENG
Date Released:
05-22-18
TAM Application Monitor - Yype 21800
Page 27
44-0009-2048-6 / ECO# 0078483
TAPE APPLICATION MONITORING
TYPE 21800
Software Version
SYS CONFIG
MONITOR
VELOCITIES
PARAMETER
TIMERS
PARAMETER
OTHER
2
Operation
(continued)
Fault Code Description
LOWER or LOWER OUTBOARD Taping Head: Tape did not apply to the box. Check tape supply
roll. Tape is broken or supply roll is empty.
101
102
LOWER or LOWER OUTBOARD Taping Head: Tape has not cut. Check case sealer adjustment
or the taping head blade
201
UPPER Taping Head: Tape did not apply to the box. Check tape supply
roll. Tape is broken or supply roll is empty.
202
UPPER Taping Head: Tape has not cut. Check case sealer adjustment or taping head blade
121
LOWER or LOWER OUTBOARD Taping Head: Internal over fl ow error. Refer to the trouble shooting
section.
221
UPPER Taping Head: Internal over fl ow error. Refer to the trouble shooting section.
25
Box Jam - Case Sealer Disabled
66
BOX INTERVAL ERROR: Boxes too close together Refer to the trouble shooting section.
Operating Sequence:
With the tape application monitoring system in place and all connections completed.
1) Turn the control box switch to the ON position. The panel indicator light brie fl y turns on and then
goes o ff , the HMI will display the main screen (Figure 4-7).
2) Turn ON the case sealer.
Note: For units with the optional remote beacon light, this light will also cycle on to o ff .
3) Run a box through your case sealer and observe any fault conditions that occur (Figures 4-6A - 4-6-H).
After Correcting the Fault Condition:
4) Reset the Tape Application Monitoring system by pressing the “Start Button” on your case sealer.
Note: If the suggestions (Figures 4-6A - 4-6H) don't clear the fault condition after attemping a reset,
refer to the troubleshooting section of this manual.
5) Return to step 2 and repeat until the system is operating normally
Figure 4-7