North American - ENG
Date Released:
05-22-18
TAM Application Monitor - Yype 21800
Page 28
44-0009-2048-6 / ECO# 0078483
•
To reduce the risk associated with mechanical and electrical hazards:
−
Read, understand, and follow all safety and operating instructions before operating or servicing
the case sealer.
−
Allow only properly trained and quali
fi
ed personnel to operate and service this equipment.
•
To reduce the risk associated with pinches, entanglement and hazardous voltage:
−
Turn electrical supply o
ff
and disconnect before performing any adjustments, maintenance or
servicing the machine or taping heads.
Warning
Adjustments
There are
fi
ve timers used to con
fi
gure this system for your application.
Note:
The timer values are in 100th of a second.
Press the “PARAMETERS TIMERS” Page to display the HMI display shown (Figure 5-1).
Set timers TH051-TH055 (in 100th of a second) as required per the application as follows:
(Reference “Settable Timers” section in this manual).
TH051 = 2 (FACTORY SETTING):
Represents the time for the leading edge of the box to travel from
box present sensor to the tape head cuto
ff
bracket (just before the tape is cut).
See below for example TH051 calculations.
TH052 = 5 (FACTORY SETTING):
Represents the time after applying measurements (Velocity V1) have
completed and tape cut measurements (Velocity V2) have begun.
TH053 = 100 (FACTORY SETTING):
Represents the time allotted for measurement (Velocity V2) after
tape would have been cut.
TH054 = 50 (FACTORY SETTING):
Represents the time after detecting an apply fault before the case
sealer is shut-o
ff
(i.e. Allows box to clear the taping head).
TH055 = 600 (FACTORY SETTING):
Represents the maximum time to process a box before enabling
a fault condition. Typically if this time is exceeded a box has jammed occurred and the case
sealer is shut down to prevent premature belt wear.
Figure 2-20
+
_
7
2
1
100
600
4
5
0
50
8
2
5
9
3
6
.
BS
CANCEL
ENTER
END
CLR
TMR T051
TMR T052
TMR T053
TMR T054
TMR T055
PAGE
EXIT
Содержание Tape Application Monitor
