3M Tape Application Monitor, Инструкция и перечень запасных частей

Страница: 30 / 62

North American - ENG
Date Released:
05-22-18
TAM Application Monitor - Yype 21800
Page 24
44-0009-2048-6 / ECO# 0078483
System Checkout & Operating Sequence
The system is now ready to use. The following steps will be used to determine proper operation of
the Tape Application Monitor:
1) From the main menu (Figure 4-4)
Press the “MONITOR VELOCITIES” Page to display the HMI display shown (Figure 4-5).
This screen is used to check the tape velocities to ensure that the both the tape apply and cut
velocities are in acceptable ranges after setup.
2) Run a box through your case sealer.
3) Watch the HMI display and note the values that appear on the screen after box goes through machine.
Verify both the apply and cut values (i.e. velocities inches/sec) for each taping head being used.
In general the expected apply value should be close to the case sealer belt speed (i.e. 15-22 for a
belt speed of 20 inches/sec) and the cut value should be close to zero (i.e. << apply value).
Note: If the unit faults the display screen will display the appropriate fault screen (Figures 4-6A - 4-6H).
4) For values outside of the ranges listed above please refer to the troubleshooting section of this manual.
Operation
(continued)
TAPE APPLICATION MONITORING
TYPE 21800
Software Version
SYS CONFIG
UPPER
LOWER
PAGE
EXIT
MONITOR
VELOCITIES
PARAMETER
TIMERS
PARAMETER
OTHER
2
Figure 4-4
Figure 4-5
APPLY CUT
18
20
4
6