Pannoramic DESK II 1.23 User’s Guide
Notes Regarding Operational Safety
The below section of this User’s Guide contains information and warnings of a kind that must be
followed by owner/operator personnel.
Warning and advisory symbols which are used on the base unit of the Pannoramic DESK II and in the
section
1.1.3 Warning and Information Labels
have the following meanings:
CAUTION
Disconnect mains plug before any kind of intervention into the device!
CAUTION
Crush hazard!
The Pannoramic DESK II, including any of its original accessory components, should not be operated
in any other way than described in section
1.1.1 Intended Use
.
Any of the following notes should be strictly observed:
Warning!
If operating the device other than specified by the manufacturer, the level of
safety will decrease.
Caution!
In the event of any non-conforming type of use, including non-conforming use
of assemblies or single parts, no liability will be assumed by the Manufacturer.
This shall also apply to service or repair work of any kind, which is performed by
other than authorized service personnel. All claims for warranty and warranty
services will be null and void in any such case.
Note:
The safety level of the equipment after servicing will be identical with level of
the original equipment.
Warning!
Insert the power cord plugs only into a grounding outlet. The protective action
must not be rendered ineffective by extension cables without protective
conductor. The Pannoramic DESK II has a built-in protection which must not be
rendered ineffective by extension cables without protective (earth-ground)
conductor.
Warning!
The operation of the instrument in explosion-risk environments is not allowed.
Warning!
If protective devices are found to be ineffective, the Pannoramic DESK II must
be shut down and precautions must be taken to prevent unintended usage. For
necessary repair work or work to restore proper operating condition, you
should contact the Thermo Fisher Scientific Customer Service.
Note:
Electric power to the Pannoramic DESK II is supplied via an external mains
power supply unit. It allows for operation at line voltages in the range of 100 V
to 240 V ±10%, 50/60 Hz, without any extra facilities required for voltage
June 4, 2018 – Rev. 2
3DHISTECH Ltd.
8(82)
For research and education uses only, not for use in diagnostic procedures.
