3D Systems sPro, Руководство пользователя

Страница: 93 / 280

SLS p r o c e s s 9 3 B R E A K O U T P A R T S
u s e r ’ s g u i d e u n l o a d i n g r c m ( r e m o v i n g t h e p a r t c a k e )
`
While it’s still warm – place the RCM lid on it
immediately to prevent uneven cooling.
Then let it sit in the room with the RCM lid
and cool down naturally.
`
After it cools down – you can move the RCM
into the BOS and begin breakout.
L
You can find material-specific information
about breaking out and cleaning parts in your
Material Guide.
U n l o a d i n g R C M ( R e m ov i n g
t h e Pa r t Ca ke )
Before You Begin
✓
Verify that the BOS RCM seal is latched in its
upright position.
✓
Know the size, shape, and placement of the
parts in the cylinder.
✓
Make sure there is adequate ventilation in the
SLS system area.
✓
Make sure the parts are cool enough to
prevent permanent deformation.
✓
If the core temperature of the part cake is
greater than 60 ºC (140 °F), do not continue.
L
If you do not have a thermometer, insert a
metal probe or breakout tool into the part cake
for 15 seconds; if it is too hot to hold, do not
continue. Also refer to the
Material Guide .
✓
Make sure the roller is at a limit.
✓
Put the SLS system software into Man Ops
mode.