3D Systems sPro, Руководство пользователя

Страница: 130 / 280

SLS p r o c e s s 1 3 0 R C M
u s e r ’ s g u i d e l o a d i n g a n d u n l o a d i n g t h e R C M
BEFORE YOU LOAD THE RCM
1
Unlock the RCM wheels and remove the
insulated RCM lid.
2
Clean the RCM as described in Cleaning the
RCM on page 128.
3
Dock the RCM in SLS system.
a Open the SLS system’s RCM bay door. Then,
with both hands on the RCM handle, roll
the RCM over to the SLS system and center
it in the bay opening.
L
Preheating does not heat the RCM handle.
b Slowly and carefully roll the RCM into the
SLS system. Push the RCM in as far as it will
go. Tooling balls on the front and sides of
the RCM help ensure proper placement.
c Step down on the RCM wheel lock lever to
lock the wheels.
d Connect the SLS system’s RCM cable to the
RCM connector
e Close the RCM bay door.
4
Put the Sinter application in Manual
Operations mode; click
Man Ops on the main
Sinter window toolbar, or select Machine >
Manual Operations .
See the Manual Operations topic in Sinter Help for
instructions.
5
Load (raise) the RCM.
Display the Piston Control dialog box via the
Manual Operations toolbar, and click the
Load button.
See Piston Control under the Manual Operations
topic in Sinter Help for instructions.
Check for small pieces of lid
insulation on the RCM after you
remove the lid. If you see any, put on
insulated gloves and vacuum them
off before you dock the RCM.
Always clean the RCM before loading
it in the SLS system. This ensure a
tight seal between the RCM cylinder
rim and the underside of the process
chamber floor.