3D Systems sPro, Руководство пользователя

Страница: 91 / 280

SLS p r o c e s s 9 1 B R E A K O U T P A R T S
u s e r ’ s g u i d e b r e a k o u t o v e r v i e w
B re a ko u t O ve r v i ew
When a build is complete, you need to remove
the sintered parts and
used powder (called the
“ part cake ”) from the RCM part cylinder.
Removing parts from the part cake is called
“ breakout .”
Before breakout, you must:
`
Cool down the part cake then remove the
RCM from the SLS system—or vice-versa.
`
Dock the RCM in the BOS; roll it into the RCM
bay, apply the foot brake, lower the rim
shield, then connect the RCM cable.
`
Start the BOS, put it in Breakout Station
mode, then select the powder transport
mode;
RECYCLE or DISPOSAL .
`
Raise the part piston a few inches to raise the
part cake BOS work table surface
About part cake cooldown before
breakout
The part cake in the RCM needs to cool down
before breakout so you can handle it safely.
You must choose where and how to cool down
the part cake after a build, specifically:
• Where – inside or outside the SLS system
• How – using a controlled or uncontrolled
temperature rampdown
Performing breakout using the BOS
(Breakout Station)
BOS
RCM
part cake
parts
Do not attempt to remove the part
cake from the RCM while it’s hot. You
can burn yourself and ruin the parts.