3D Systems sPro, Руководство пользователя

Страница: 87 / 280

SLS p r o c e s s 8 7 B U I L D P A R T S
u s e r ’ s g u i d e m o d i f y i n g a b u i l d i n p r o g r e s s
M o d i f y i n g a B u i l d i n Pr o g r e s s
Make changes during a build with the Build
Modify dialog box shown above.
To display it, click the Change Parameter button;
if the build is paused, click the Change Profiles/
Prime Cycle button in the Pause Build dialog
box.
Modifying Part and Build Profiles
Click the Modify Build Profile or Modify Part
Profile button to display a profile editor dialog
box from the Build Setup application. Use the
Change Build Mode button to access the
Change Build Mode dialog box. Modify
parameters as described in the Build Setup Help.
L
You can find definitions of the parameters in
the Build Setup Help.
In most respects these dialog boxes work just as
they do in the Build Setup software, with the
following differences:
`
Settings for Z levels below the current are
yellow and cannot be changed.
`
The current Z level is displayed as a green
vertical line in the parameter chart.
`
In the Build Profile Editor , a new button
appears, the button. Use this button to
make a profile change at the current Z level.
Click the button and a new row appears in
the current build stage. Click in the
Value
column and enter a value, then click Apply .
When the system applies the value, it
updates the row to the current Z level.
`
If you make changes near the current Z, the
system may not be able to apply them. If you
do not get the message
The parameter
change has been applied after clicking
Apply , try again at a higher Z. (There is no
message when the attempt fails.)