3D Systems sPro, Руководство пользователя

Страница: 69 / 280

SLS p r o c e s s 6 9 P R E P A R E T O B U I L D
u s e r ’ s g u i d e d o c k i n g t h e R C M i n t h e S L S s y s t e m
D o c k i n g t h e R C M i n t h e S L S Sys t e m
After you (optionally)
preheat the RCM and
you’re ready to build,
follow these basic
steps to dock the RCM
in the SLS system. After
you dock the RCM, it’s ready for loading.
1
Unlock the RCM wheels and remove the
insulated RCM lid.
2
Open the SLS system’s RCM bay door, then,
with both hands on the RCM handle, roll the
RCM over to the SLS system and center it in
the bay opening.
L
Preheating does not heat the RCM handle.
3
Slowly and carefully roll the RCM into the SLS
system. Push it in as far as it will go.
4
Step down on the RCM foot brake to keep it
from rolling back.
5
Close the RCM bay door.
Before you start your
build, you will need to
run Sinter and “load”
the RCM in the SLS
system; i.e., raise it up until the rim of the
part
cylinder seals against the underside of the
process chamber floor.
Check for small pieces of lid
insulation on the RCM after you
remove the lid. If you see any, put
on insulated gloves and vacuum
them off before you dock the
RCM.
For complete RCM
loading instructions, see
Loading and Unloading
the RCM
on page 129
See Loading the RCM on
page 75
Dock preheated RCM in SLS system
before build