3D Systems sPro, Руководство пользователя

Страница: 92 / 280

SLS p r o c e s s 9 2 B R E A K O U T P A R T S
u s e r ’ s g u i d e b r e a k o u t o v e r v i e w
The table below summarizes your part cake
cooldown options before breakout:
WHERE TO COOL DOWN THE PART CAKE
If you cool down the part cake inside the SLS
system, leave the RCM loaded until the part cake
reaches its final cooldown temperature.
Unloading the RCM after a build
After a build and before breakout, you must
remove the RCM with the part cake from the SLS
system. You can remove it while it’s still warm or
let it cool down inside the SLS system.
If you remove the RCM from the SLS system...
PART CAKE
COOLDOWN
LOCATION
PART CAKE COOLDOWN METHOD
CONTROLLED UNCONTROLLED
RCM connected inside
the SLS system
Use the Cooldown Wizard in Build Setup
to create a custom cooldown profile for
your build. Leave the RCM loaded until
the SLS system indicates that the build is
complete.
Leave the RCM loaded after the build
finishes. Do not remove it until the part
bed temperature is at or slightly above
room temperature. Wear insulated
gloves if you need to remove the RCM
before it cools down.
RCM disconnected
outside the SLS system
Not available.