3Com CoreBuilder 7000, Руководство по управлению

Страница: 212 / 516

212 C
HAPTER
7: C
ONFIGURING
V
IRTUAL
C
HANNELS
Update Protocol
Timer Resolution
Updates the timer resolution of the CoreBuilder 7000 family ATM switch.
The default timer resolution is 500 msec (0.5 secs), the minimum timer
resolution is 100 msec, and there is no upper limit. For more
information,see “Display Protocol Timer Resolution” on page 210, and
“Timer Resolution” on page 113 in the Operations Guide.
This command causes the new timer resolution to be activated in the
current session.
The new value of timer resolution is not stored in flash until the Save
Protocol Timer Resolution command described in the next section is
performed.
Command Actions
Command Result
Example
Enter:
1 1 4 1 2 250
The following message is displayed:
Timer resolution was set. Use ‘SAVE’ to save it on flash.
The timer resolution is updated to 250 msec. All timers are affected.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(4) SIG: Signaling setup
(1) RES: Timer Resolution setup
(2) SET: Set Timer Resolution
Enter a parameter at the prompt
Parameter Format or Range
Timer Resolution in millisec; Range: >=100
Direct access sequence:
1 1 4 1 2
System action taken:
The timer resolution is activated in the current session.
System message display:
Timer resolution was set. Use ‘SAVE’ to
set it on flash.