3Com CoreBuilder 7000, Руководство по управлению

Страница: 202 / 516

202 C
HAPTER
7: C
ONFIGURING
V
IRTUAL
C
HANNELS
Update Signaling
Protocol Profile
Updates the signaling protocol profile for the selected port for the current
session. For details, “Display Signaling Protocol Profile” on page 200.
This command causes the new signaling protocol parameters to be
activated in the current session. The new value is not stored in flash until
you use the SAV command (“Save Signaling Protocol Configuration” on
page 206).
If the new value of the signaling protocol parameters is not stored in
flash, the system reverts to the previous value of the signaling protocol
parameters the next time it reboots.
Command Actions
Command Result
Example
Enter:
1 1 4 5 2 3.2 1
The following message is displayed:
Parameter was set. Use 'SAVE' to save it on flash.
The signaling protocol for port 3.2 is updated to Network.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(4) SIG: Signaling setup
(5) SPS: Signaling protocol setup
(2) SPR: Set profile of port
Enter a parameter at the prompt
Parameter Format or Range
Port ID slot.port (
0.0
for all ports)
Signaling profile
0
for user profile
1
for network profile
Direct access sequence:
1 1 4 5 2
[parameters]
System action taken: The signaling protocol profile is updated. for the
specified port.
System message display:
Parameter was set.