1-8
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 1ms, Average = 1ms
Precautions
When configuring a static route, note the following:
1) If you do not specify the preference when configuring a static route, the default preference will be
used. Reconfiguration of the default preference applies only to newly created static routes.
Currently, the Web interface does not support configuration of the default preference.
2) When configuring a static route, the static route does not take effect if you specify the next hop
address first and then configure it as the IP address of a local interface, such as a VLAN interface.
3) When specifying the output interface, note that:
z
If NULL 0 interface is specified as the output interface, there is no need to configure the next hop
address.
z
If you want to specify a broadcast interface (such as a VLAN interface) as the output interface,
which may have multiple next hops, you need to specify the next hop at the same time.
4) You can delete only static routes on the
Remove
tab.
Содержание 2928 - Baseline Plus Switch PWR
