3Com 2928 - Baseline Plus Switch PWR, Руководство пользователя

Страница: 302 / 505

1-4
Item Description
Preference
Set a preference value for the static route. The smaller the number, the
higher the preference.
For example, specifying the same preference for multiple static routes
to the same destination enables load sharing on the routes, while
specifying different preferences enables route backup.
Next Hop Type the nexthop IP address, in dotted decimal notation.
Interface
Select the outgoing interface.
You can select any available interface, for example, a virtual interface,
of the device. If you select NULL 0, the destination IP address is
unreachable.
Static Route Configuration Examples
Network requirements
The IP addresses of devices are shown in Figure 1-3 . IPv4 static routes need to be configured on
Switch A, Switch B and Switch C for any two hosts to communicate with each other.
Figure 1-3
Network diagram for IPv4 static route configuration
Configuration outlines
1) On Switch A, configure a default route with Switch B as the next hop.
2) On Switch B, configure one static route with Switch A as the next hop and the other with Switch C
as the next hop.
3) On Switch C, configure a default route with Switch B as the next hop.
Configuration procedure
1) Configure the IP addresses of the interfaces (omitted)
2) Configure IPv4 static routes
# Configure a default route to Switch B on Switch A.
z
After you log in to the web interface of Switch A, select
Network
>
IPv4 Routing
from the
navigation tree and then click the
Create
tab to enter the page shown in Figure 1-4 .