ZyXEL Communications PMG5318-B20A, User Manual

Page: 36 / 168

Chapter 4 WAN
PMG5318-B20A User’s Guide
36
4.3.3 WAN Interface Type - Bridging
Select Bridging as the WAN interface type to open the following screen.
Figure 12
Internet Access Setup - Bridging
The following table describes the labels in this screen.
Preference This field displays the router preference (Low, Medium or High) the gateway
assigned to the GPON Device. The GPON Device sends this preference in the router
advertisements to tell hosts what preference they should use for the GPON Device.
This helps hosts to choose their default router especially when there are multiple IPv6
routers in the network.
Note: Make sure the hosts also support router preference to make this function work.
Prefix Enter the IPv6 prefix provided by your ISP.
Prefix Length Enter the bit number of the IPv6 subnet mask provided by your ISP.
Apply Click Apply to save the changes.
Cancel Click Cancel to begin configuring this screen afresh.
Table 6
Internet Access Setup - IP (continued)
LABEL DESCRIPTION
Table 7
Internet Access Setup - Bridging
LABEL DESCRIPTION
General
WAN interface type Select Bridging as the method of encapsulation used by your ISP from the drop-
down list box.
Bridging LAN ports Select one or more LAN or wireless port(s) to bind with this WAN connection. Only the
selected ports here can use this WAN connection.
Service
Service Description Enter a description to identify this WAN interface.
802.1Q VLAN ID This shows the VLAN ID assigned to traffic for this connection. Click Edit to open a
screen where you can select a different VLAN ID. See
Section 4.3.4 on page 37 for
information on this screen.
802.1P Priority
Method Select the 802.1P priority method to be assigned to traffic sent through this
connection.
WAN service type This field displays Bridge.