Chapter 14 File Manager
NWA5000 / WAC6500 Series User’s Guide
163
While configuration files and shell scripts have the same syntax, the NWA/WAC applies
configuration files differently than it runs shell scripts. This is explained below.
You have to run the aforementioned example as a shell script because the first command is run in
Privilege
mode. If you remove the first command, you have to run the example as a configuration
file because the rest of the commands are executed in
Configuration
mode.
Comments in Configuration Files or Shell Scripts
In a configuration file or shell script, use “#” or “!” as the first character of a command line to have
the NWA/WAC treat the line as a comment.
Your configuration files or shell scripts can use “exit” or a command line consisting of a single “!” to
have the NWA/WAC exit sub command mode.
Note: “exit” or “!'” must follow sub commands if it is to make the NWA/WAC exit sub
command mode.
In the following example lines 1 and 2 are comments. Line 5 exits sub command mode.
! this is from Joe
# on 2010/12/05
wlan-ssid-profile default
ssid Joe-AP
qos wmm
security default
!
Errors in Configuration Files or Shell Scripts
When you apply a configuration file or run a shell script, the NWA/WAC processes the file line-by-
line. The NWA/WAC checks the first line and applies the line if no errors are detected. Then it
continues with the next line. If the NWA/WAC finds an error, it stops applying the configuration file
or shell script and generates a log.
You can change the way a configuration file or shell script is applied. Include
setenv stop-on-
error off
in the configuration file or shell script. The NWA/WAC ignores any errors in the
configuration file or shell script and applies all of the valid commands. The NWA/WAC still generates
a log for any errors.
14.2 Configuration File
Click
Maintenance > File Manager > Configuration File
to open this screen. Use the
Configuration File
screen to store, run, and name configuration files. You can also download
Table 78
Configuration Files and Shell Scripts in the NWA/WAC
Configuration Files (.conf)
Shell Scripts (.zysh)
•
Resets to default configuration.
•
Goes into CLI
Configuration
mode.
•
Runs the commands in the configuration file.
•
Goes into CLI
Privilege
mode.
•
Runs the commands in the shell script.
Summary of Contents for NWA5121-N
Page 10: ...10 PART I User s Guide...
Page 38: ...38 PART II Technical Reference...
