ZyXEL Communications NBG-417N, User Manual, Page: 22 / 279

Chapter 1 Introduction
User
’
s Guide
23
The following table describes the LEDs and the WPS button.
Table 1 Front Panel LEDs and WPS Button
LED COLOR STATUS DESCRIPTION
POWER Green On The NBG4115 is receiving power and functioning
properly.
Off The NBG4115 is not receiving power.
WLAN Green On The NBG4115 is ready, but is not sending/
receiving data through the wireless LAN.
Blinking The NBG4115 is sending/receiving data through
the wireless LAN.
The NBG4115 is negotiating a WPS connection
with a wireless client.
Off The wireless LAN is not ready or has failed.
WAN Green On The NBG4115 has a successful 10/100MB WAN
connection.
Blinking The NBG4115 is sending/receiving data through
the WAN.
Off The WAN connection is not ready, or has failed.
LAN 1-2 Green On The NBG4115 has a successful 10/100MB
Ethernet connection.
Blinking The NBG4115 is sending/receiving data through
the LAN.
Off The LAN is not connected.
3G Green On The NBG4115 has a 3G card installed and is
communicating with routers.
Blinking The NBG4115 is transmitting and/or receiving
data from routers through an installed 3G card.
Off There is no 3G card installed.
Internet Green On The NBG4115 has received an IP address
through either the WAN or WLAN interface and
can connect to the Internet.
Off The NBG4115 has not received an IP address
through either the WAN or WLAN interface and
as such cannot connect to the Internet.
WPS Button Press this button for 1 second to set up a wireless connection via WiFi
Protected Setup with another WPS-enabled client. You must press the
WPS button on the client side within 120 seconds for a successful
connection.
C
om
pan
y
C
on
fiden
tial