ZyXEL Communications AMG1202-T10A, User Manual, Page: 99 / 296

Chapter 8 Wireless LAN
AMG1202-T10A User’s Guide
99
8.2 The AP Screen
Use this screen to configure the wireless settings of your ZyXEL Device. Click Network > Wireless
LAN to open the AP screen.
Figure 43
Network > Wireless LAN > AP
The following table describes the labels in this screen.
Table 26
Network > Wireless LAN > AP
LABEL DESCRIPTION
Wireless Setup
Enable
Wireless LAN Click the check box to activate wireless LAN.
Channel
Selection Set the operating frequency/channel.
Common Setup
Enable SSID
Autogeneration Click the check box to have the ZyXEL Device generate an SSID.
Name (SSID) The SSID (Service Set IDentity) identifies the service set with which a wireless
device is associated. Wireless devices associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII
characters) for the wireless LAN.
Note: If you are configuring the ZyXEL Device from a computer connected to the
wireless LAN and you change the ZyXEL Device’s SSID or WEP settings, you
will lose your wireless connection when you press
Apply to confirm. You must
then change the wireless settings of your computer to match the ZyXEL
Device’s new settings.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Security Mode See the following sections for more details about this field.
MAC Filter This shows whether the wireless devices with the MAC addresses listed are allowed
or denied to access the ZyXEL Device using this SSID.