ZyXEL Communications AMG1202-T10A, User Manual

Page: 102 / 296

Chapter 8 Wireless LAN
AMG1202-T10A User’s Guide
102
8.2.3 WPA(2)-PSK
Use this screen to configure and enable WPA(2)-PSK authentication. Click Network > Wireless
LAN to display the AP screen. Select WPA-PSK or WPA2-PSK from the Security Mode list.
Figure 46
Network > Wireless LAN > AP: WPA(2)-PSK
The following table describes the wireless LAN security labels in this screen.
Table 29
Network > Wireless LAN > AP: WPA(2)-PSK
LABEL DESCRIPTION
Security Mode Choose WPA-PSK or WPA2-PSK from the drop-down list box.
Encryption Select the encryption type ( TKIP , AES or TKIP/AES ) for data encryption.
Select TKIP if your wireless clients can all use TKIP.
Select AES if your wireless clients can all use AES.
Select TKIP/AES to allow the wireless clients to use either TKIP or AES.
Enable Key
Autogeneration Click the check box to have the ZyXEL Device generate the Pre-Shared Key.
Pre-Shared Key The encryption mechanisms used for WPA(2) and WPA(2)-PSK are the same.
The only difference between the two is that WPA(2)-PSK uses a simple
common password, instead of user-specific credentials.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
WPA Group Key
Update Timer The Group Key Update Timer is the rate at which the AP (if using WPA(2)-
PSK key management) or RADIUS server (if using WPA(2) key management)
sends a new group key out to all clients. The re-keying process is the WPA(2)
equivalent of automatically changing the WEP key for an AP and all stations in a
WLAN on a periodic basis.