ZyXEL Communications AMG1202-T10A, User Manual

Page: 58 / 296

Chapter 5 Internet and Wireless Setup Wizard
AMG1202-T10A User’s Guide
58
5.2.1 Manual Configuration
1
If the ZyXEL Device fails to detect your DSL connection type but the physical line is connected,
enter your Internet access information in the wizard screen exactly as your service provider gave it
to you. Leave the defaults in any fields for which you were not given information.
Figure 15
Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
Table 7
Internet Access Wizard Setup: ISP Parameters
LABEL DESCRIPTION
Mode Select Routing (default) from the drop-down list box if your ISP give you one IP
address only and you want multiple computers to share an Internet account. Select
Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly.
If you select
Bridge , you cannot use Firewall, DHCP server and NAT on the ZyXEL
Device.
Encapsulation Select the encapsulation type your ISP uses from the Encapsulation drop-down
list box. Choices vary depending on what you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483 .
If you select Routing in the Mode field, select PPPoA , RFC 1483 , ENET ENCAP
or PPPoE .
Multiplexing Select the multiplexing method used by your ISP from the Multiplex drop-down list
box either VC-based or LLC-based.
Virtual Circuit
ID VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual
circuit. Refer to the appendix
for more information.
VPI Enter the VPI assigned to you. This field may already be configured.