MANAGING INFUSION
Z-800F Instructions for Use.
45
P/N 800F-IFU-2602, Rev. O
PROTOCOL MODE INFUSION
Access Protocol Mode Infusion
A user may choose to save the current infusion
parameters to the pump as a pre-defined protocol. The
saved protocol can be retrieved in the future to
automatically program a current infusion. This can
eliminate repetitive programming for selected commonly
used infusion regimens.
The Protocol infusion mode may be accessed after
entering a new infusion.
1.
Turn on the pump and select NEW INFUSION, or, if
the pump is in infusion parameter programming
screen, press Home key to access home page.
2.
The home page should be displayed. Highlight
PROTOCOL
using Up/Down arrows and press
SELECT
.
3.
The pump will display the protocol names saved on
the pump. There are up to 8 protocols that can be
saved on the pump.
4.
Choose one of the protocols by highlighting the name
of the protocol. Press the SELECT key to program the
highlighted protocol.
5.
The pump will display the Programming screen of the
pre-defined infusion mode with pre-defined infusion
parameters populated.
Start Infusion
Verify the displayed infusion parameter entries (Primary
Rate, Primary VTBI, Secondary Rate, and Secondary
VTBI). If a clamp is engaged, remove the clamp. Press
RUN/STOP
key to start the infusion.
RUN/STOP
key