Zontes ZT125-M 2022, Maintenance Manual

Page: 147 / 218

147
/
218
outlet pipe toward the rear wheel to pull out the throttle
valve body.
d. Pull the air outlet pipe to the right side of the vehicle
to expose the two M6×30 bolts that fix the starter motor,
and remove them with an 8# sleeve. After removing the
bolts, remove the starter motor from the engine in the
direction indicated by the big arrow.
e. When reassembling, make sure not to omit the O ring
that comes with the starter motor, and align the teeth of
the electric starter reduction gear. Note that the O-ring
needs to be correctly assembled into the box, as it will
cause leakage if cut edges occur. Torque of the two bolts
for fixing the starter motor: 12±1.5 N.m (1.2±0.2 kgf.m, 9±1
lbf.ft). And mark with a marker.
2. Disassemble the starter motor
Caution:
●If the magnet tile pulls the electric pole towards the motor housing, the coil may be damaged.
●When installing the electric motor from the slot of the starter motor housing to the housing, make the commutator bar face
the rear side;
●When installing the back cover of the starter motor, please align the marking line with the index line;
●When installing the front cover of the starter motor, pay attention to prevent damage to the oil seal lip of the electric drive
shaft, and align the marking line of the front cover with the index line on the motor housing.
Disassemble and assemble the starter motor as shown in the figure below.
●The M125 steps are similar to the M310, taking the M310 as an example.