Zontes ZT125-M 2022, Maintenance Manual

Page: 161 / 218

161
/
218
f. Pull the two water pipes out of the water pipe clamp,
which is made of plastic, and pay attention to your strength.
g. Use an 8# socket to remove the two M6x22 bolts on
both sides and remove the tank assembly.
h. After loosening the hoop with the hoop pliers,
disassemble the radiator assembly. See the figure below for
the distribution of each hoop.
M350 Coolant system hoop/clamp distribution map
1-Water pipe clamp (φ9) 2 - Water pipe clamp (φ26)*3 3 -
Water pipe clamp (φ24)*2 4 -Water pipe clamp (26)
M350 Thermostat assembly and small loop
1- Thermostat assembly 2-M6x22 bolts *2 3-M6x12 bolts
*2,4- Water pipe hoop (φ25), 5 - Water pump cover inlet
pipe, 6- W ater pump cover hoop (φ24), 7 - Water pipe hoop
(φ26) * 2, 8 - Water pump cover outlet pipe, 9- Water pump
cover assembly
Note: The bolts at the thermostat are exhaust bolts, and the
bolts at the pump cover are coolant drain bolts. There are
φ5.6×φ1 O rings in both places, which need to be replaced
once removed.
a.
用抱箍钳分别移开抱箍⑷、抱箍⑹和抱箍⑺，将
水管⑸和⑻分离
.
将抱箍从水管上取下
.
b. Use the 8# sleeve to remove the 2 bolts (2), remove the
thermostat assembly, and remove the 16.5×1.95 O ring from
the thermostat assembly. Once removed, the O ring needs to
be replaced.
Before reassembly, the joint surface should be cleaned
and the O-ring should not be leaky and properly assembled.
The hoop should be stuck to the inside of the convex
platform to prevent loosening. Torque: 12± 1.5N.m (1.2±
0.2kgf.m,9±1 lbf.ft).