Zontes ZT125-M 2022, Maintenance Manual

Page: 115 / 218

115
/
218
If the battery power supply fails to start, it can be charged
through the PKE charging port.
M125/310 charging
Open the right storage box cover, insert the buckle with
your fingernail or a thin flat-blade screwdriver, press inward
and pull out the buckles on both sides, and then remove the
right storage box cover.
Open the protective cap①, pull out the PKE insurance③,
first insert the DC output plug of the charger provided with
the car into the PKE charging port; then connect the charger
input AC terminal to 110-220V household AC.
① is the protective cap for the charging DC interface;②
is the charging insurance;③ is the PKE insurance, which
must be unplugged when charging the battery through the
DC interface with the charger;④ is the TEST button, which
function is same as the unlock button on the auxiliary switch.
M350 charging
Press the button indicated by the arrow to open the right
storage box cover.
Press down the central cylinder of the expansion nail with
4 # hexagonal socket, and then take down the expansion nail.
Pull out the cover plate. Note that the back of the cover plate
is pasted with a non inductive antenna and cannot be pulled
by force.
Unplug the PKE fuse, open the rubber plug and insert it
into the original standard charger DC plug. Then plug the AC
socket into the 110-220V power supply. Insert the fuse after
filling. The battery damage caused by using inferior charger is
not included in Three Replacement Policy.
● Note: When reassembling batteries or fuses, please
remember to reset the EFI hardware. For details, see the
service information in this section.
2. Headlight height adjustment
Caution:
●The height of the headlights is too high or too low, which
will affect safe driving. The light height should be adjusted
reasonably according to the presence or absence of the
occupant and the weight change of the driver.
●It is strictly forbidden to adjust the light height during
riding. It is recommended to find a smooth road with a
straight line distance of about 150 meters for adjustment
under the premise of not affecting traffic safety at night.
Use a polished rod with a diameter of 6mm (0.24 in) and a
length of 150
～
200mm (6
～
8 in) with a Phillips screwdriver
from just below the headlights and go up through the
dimming hole of the horn bracket, and align it with the
serration of the dimming bolt; Rotate the clockwise to turn
down, and counterclockwise to turn up.