Zontes ZT125-M 2022, Maintenance Manual

Page: 57 / 218

57 / 218
e. Use 4# inner hexagon to remove the 3 M6×14 bolts that
surround the right side.
f. Use your fingers or a plastic crowbar to forcefully break
out from the arrow point until the bolt near the arrow point
is exposed. Because there are still bolts on the upper part
that have not been removed, it cannot be removed directly.
g. Use 5# inner hexagon to remove the M6×16 bolt,
remove bushing.
h. Use 4# inner hexagon to remove 7 pcs M6×14 bolts.
i. Use 4# inner hexagon to press down the center
cylindrical pins of the 3 swell nails on the right, and then
remove the swell nails. Remove the M6×14 bolt on the right
front part with a 4# inner hexagon. For instructions on
disassembly and assembly of swell nails, please refer to the
pre-service instructions in this chapter.
j. Press the blue part inward at the junction of green and
blue as shown in the figure; pull the red and green
components outward. Then apply force from the rear wheel
to the front wheel along the junction of the red and blue
parts, push the red part outwards, and force the blue parts
inward to break apart. Remove the right pedal and right
pedal trim cover assembly.
k. Use a dust blow gun to blow away the dust and debris
near the spark plug.
l. Pull out the ignition coil high-voltage cap.
m. Remove the spark plug by turning it counterclockwise
with the vehicle-mounted tool or special 16# spark plug
sleeve.
n. It is recommended to seal the spark plug installation
hole with masking paper or other soft plastic bags to prevent
foreign matter from entering the engine.