Zontes ZT125-M 2022, Maintenance Manual

Page: 48 / 218

48 / 218
7. Inspection air filter waste oil pipe
Wipe clean the surface of the waste oil pipe and visually
check for liquid. If so, use pliers to remove the waste oil pipe
clamp, clean the waste oil pipe, and then reinstall it. Pay
attention to increase the frequency of inspection
appropriately when the air humidity is high.
8. Reinstall
a. Refer to the steps of removing the filter housing to
install the housing back.
b. Replace the air inlet baffle and the air inlet cover of the
replaced air inlet filter element.
c. If the original scooter has a shock-proof sponge, it needs
to be placed well, if not, go to the next step.
d. Clip M6×14 bolts to the inner step hole of the engine left
cover, and then use a 4# inner hexagon to penetrate from
the outside and hold the bolt
.
e. Align the left bolt with the mounting hole and tighten it.
f. Before installing other bolts, install the exposed sponge
and plug it back into the left cover.
g. Use 4# inner hexagon to install the other 4 M6×14 bolts.
Replace the decorative buckle.
●The vehicle must be parked on a flat and stable ground or a
lifting platform.
●The operation can only be perf ormed after the engine has
cooled down completely.
●The air filter element and the engine air inlet element
should be replaced every 10000km (621 mile).