Page 17
Page 16
MagnaPool™ | Installation Manual
7.2
Initial start-Up
The following setting must be configured at the
initial start up of the device. Settings can be
changed or updated at a later time using the
general menu, details can be found in Section 8.
From factory, the hydroxination is set at 50 %. It can
be set between 0 and 100 % in 10 % increments
from the “main screen” by pressing
. The set
value is valid until the next modification.
7.2.1
System Power
1. Press
to enter Standby mode.
2. Press
again to start hydroxination and
filtration.
3. Press and hold
for 3 seconds to turn the
controller off.
7.2.2
Language
1. Press
.
2. Use
to select “Language”
then press .
3. Use
to browse language the options.
4. Press
to make a selection.
<
-LANGUAGE
MAIN MENU
<
-ENGLISH
-FRANCAIS
-ESPANOL
-ITALIANO
-DEUTSCH
-NEDERLANDS
-PORTUGUES
-CESTINA
-MAGYAR
-SVENSKA
-SLOVENSKY
SELECT LANGUAGE
7.2.3
Set Clock
1. Press
.
2. Use
to select “Programming”
then press .
3. Use
to select “Clock”
then press .
4. Use
to set hour then press .
5. Use
to set minutes then press .
NOTE: Press and hold
or to increment time by 10.
6. Press
to exit.
<
-PROGRAMMING
-LOW MODE
-SLAVE MODE
MAIN MENU
23:04
CLOCK SET UP
7.2.4
Boost Mode
In some cases, the pool may require a higher than
normal hydroxination level such as in cases of high
use, poor weather or at the start of the season. Boost
mode is used to increase the chlorine level quickly.
Boost mode lasts for 24 cumulative hours at 100%
production output. If the program is set to perform
hydroxination 12 hours per day, Boost mode will
be active for 12 hours on the first day and 12 hours
on the second day. If the filter pump is connected
to the controller, the filter pump will operate in
Boost mode also. The controllers operating times
including filtration schedules are temporarily
ignored for the duration of the Boost mode. Once
Boost mode completes, the controller and filter
pump will resume programmed operations.
NOTE:
If the device is equipped with a Dual Link
module, the Boost mode will not take the ORP
value into account. The Boost mode takes
priority over the ORP regulation
1. Press
.
23:04 ON
BOOST MODE 23:59
2. If the controller is in Low/Cover mode you will
need to confirm that you want Boost mode to
override Cover or Low mode settings.
7.2.5
Low Mode
Low mode is designed to reduce chlorine
production in situations where the pool is covered
or when pool use is limited. Chlorine production
needs will be lower when pool use is low and/or
when pool water is not exposed to UV rays etc.
Low mode output can be set in the main menu
settings for Low mode. Low can be set from
0%-30% in 10% increments. Programs are still
active while the controller is in Low/Cover mode.
1. To manually enter Low mode press
.
2. To exit Low mode press
again.
23:04 ON
LOW MODE 10%
