![background image](http://html1.mh-extra.com/html/zodiac/magnapool/magnapool_installation-manual_3986087011.webp)
Page 11
Page 10
MagnaPool™ | Installation Manual
Flow
Flow
Inlet
Outlet
Figure 15. POD Orientation
3. Assemble the POD around the pipe, the tabs
will click into place.
5.4
Install the POD Cap
1. Place the POD cap on the POD assembly.
The cover and POD assembly are keyed for
proper orientation. Use caution to ensure the
POD O-ring is clean and properly seated.
2. Align the arrow on the POD with the locking ring.
Figure 16. POD Locking Ring Orientation
3. Tighten the locking ring with the locking collar
tool until snug. Do not overtighten.
5.5
Install and Calibrate
the Sensor(s)
1. Install the sensor holder(s) into the correct
port on the POD cap. Remove the cap plug if
necessary.
NOTE:
The ORP sensor is with Dual Link module only.
Sensor
Holder
Cap
Plug
Figure 17. Sensor Holder Installation
2. Carefully remove the protective tube
from the sensor.
3. Rinse the end of the sensor with tap water.
Shake off excess water.
4. Carefully screw the sensor(s) into sensor holder.
Figure 18. pH/ORP Sensor Installation
5. Calibrate the sensor(s).
(See Section 5.7. Calibration Procedure)
To maintain accurate and reliable operation, the
sensors must be calibrated before the initial use
of the controller with pH/Dual Link module. After
initial calibration, it is recommended to recalibrate
sensors every few months.
6. Connect the sensor lead(s) to the module
at the base of the controller (pH = blue),
(ORP = yellow).
pH
ORP
Figure 19. pH/ORP Connection Ports