![background image](http://html1.mh-extra.com/html/zodiac/magnapool/magnapool_installation-manual_3986087021.webp)
Page 21
Page 20
MagnaPool™ | Installation Manual
<
-PH SETUP
-ORP SETUP
-LOW MODE
MAIN MENU
<
-PH SETPOINT
-PH CALIBRATION
-ACID PUMP
-TEST DOSAGE
PH SETUP
<
-1 POINT
-2 POINTS
PH CALIBRATION
<
PH SENSOR INTO
BUFFER PH 7
START
STEP 1
PH 7 CALIBRATION
PROCEEDING
STEP 1
<
PH 7 CALIBRATION
COMPLETE
GO TO STEP 2
STEP 1
IN TAP WATER
RINSE SENSOR
<
PH SENSOR INTO
BUFFER PH 4
START
STEP 2
PH 4 CALIBRATION
PROCEEDING
STEP 2
<
PH 4 CALIBRATION
COMPLETE
CONTINUE
STEP 2
8.4
ORP Sensor Calibration
1. Turn on power to the controller.
2. Turn off the pool pump and close valves as
necessary to isolate the cell and sensors.
3. Press
.
4. Use
to select “ORP Setup” then press .
5. Use
to select “ORP Calibration”
then press .
6. Remove the ORP sensor from the POD.
7. Insert the ORP sensor into the
470 mV buffer solution.
8. Press
while “Start” is selected.
9. Press
to exit.
<
-ORP SETUP
-LOW MODE
-SLAVE MODE
MAIN MENU
<
-ORP SETPOINT
-ORP CALIBRATION
ORP SETUP
<
-BUFFER 470 MV
START
ORP CALIBRATION
<
PROCEEDING
ORP CALIBRATION
<
COMPLETE
ORP CALIBRATION
8.5
Setpoint(s)
Current setpoints are displayed on the Home
screen whenever the controller is ON.
<
PRODUCTION AUTO
PH=7.2
ORP=500
SET=7.0
SET=750
23:04 ON
8.5.1
Establish the pH Setpoint
Establishing the pH setpoint determines when acid
will be added to the system to decrease the pH of
the water.
1. Press
.
2. Use
to select “pH Setpoint”
then press .
3. Use
to select value then press .
4. Press
to exit.
<
-PH SETUP
-ORP SETUP
-LOW MODE
MAIN MENU
<
-PH SETPOINT
-PH CALIBRATION
-ACID PUMP
-TEST DOSAGE
PH SETUP
<
7.2
RECOMMENDED
7.0-7.4
PH SETPOINT
• Default pH setting is 7.2.
• Use
to change the setpoint
by increments of 0.1.
• pH setpoint range is from 6.8 (min) to 7.6 (max).
8.5.2
Establish the ORP Setpoint
Establishing the ORP setpoint determines when
chlorine should be produced by the system to
chlorinate the water. Free chlorine level should be
checked every few days after initial installation.
1. Press
.
2. Use
to select “ORP Setup” then press
.
3. Use
to select “ORP Setpoint then press
Current Sensor
Measures
Setpoints